|
T64 / OMTech 150w CO2 LaserShopTech ShopIDT64Name150w CO2 LaserPower CategoryCordedManufacturerOMTechModel Number150W 40x63LocationLaser Cutter RoomGood Forplywood sheet, acrylic, etc.Safety NotesNEVER CUT anything with Chloride in it or other hazardous gases!
NO PVC/vinyl Chloride noxious gas!
NO fake leather/pleather Chloride noxious gas!
NO ABS Cyanide gas.
NO HDPE Fire and Melts.
NO PolyStyrene/PolyPropylene Foam #1 cause of fires.
NO Fiberglass Fumes
NO Carbon Fiber FumesUsage NotesBe sure to understand the machine.
Know where the fire extinguisher is, Attempt to put out with blanket first!
Do not use over 50% power (Extends laser life enormously)
Be sure fume extractor is running.
Safe Materials:
Wood, Paper, Cardboard (move quick to avoid fire), Cloth, Leather, magnet sheet, etc.
RDWorks software Setting on new install:
Config > System > Configuration > Homing = Top Right
WIP Steps:
0) Have safety glasses on. for you and anyone else in room.
1) Make sure water circulator is on
2) Load your material. If Acrylic stand it off the honeycomb a bit for much better finish
2) Load file using USB drive (exported in RDworks via [SaveToUFile])
Place usb drive in the upper port on right side of machine.
Now you must copy the file from usb drive onto system memory and then select that file.
Menu > File > Read U Disk > Select file > Save To Memory > Esc > The select file.
3) Set origin to top left, Press ORIGIN. Then can press Frame to confirm outer dimensions
4) Confirm laser focal height Some how.... .
5) Close lid
5) Press Start At top. be prepared to press stop/E-Stop if any problems.
6) Clean up any cut offs left in bed.
7) Remove USB drive and Delete project from laser memory if it was a one off
8) Power down the laser and chiller
Troubleshooting:
If getting ghosting/double lines when engraving -
Open Lightburn -> device settings (wrench/tool icon towards middle top of screen)
allows you to set line shift specifications. Read: https://github.com/LightBurnSoftware/Documentation/blob/master/ScanningOffsetAdjustment.md#scanning-offset-adjustment
For more info.
Errors:
Machine says 'Not enough Extend Space' - means your engraving is too close to edge of bedSpecs1600mm x 1000mm (63"x40")Maintenance NotesClean out tray at bottom if anything collecting.Manufacturers Product Linkhttps://omtechlaser.com/products/150w-co2-laser-engraver-cutter-usb-gb16-usInstructional Link 1https://cpl.org/wp-content/uploads/NEVER-CUT-THESE-MATERIALS.pdfLIST EDIT |
